Dauth's little corner of Science
#1
Posted 29 October 2007 - 23:27
I'm well versed in Maths and Physics, with a reasonable knowledge of Chemistry but I can only really expand on biology using logic and physics.
And the first one, eth-oxy-ethane (or ether to those over about 35).
It is possible to pour this compound into a trough and light it, then it will climb the trough burning cleanly.
The flames cannot be put out using water as the ether will float on the water and continue burning.
Due to the volatility of ether if you leave a bottle unstopped and light a bunden at the other end of the room, the ether when it covects to the plasma of the flame will ignite and you will see the ether across the room catch fire back towards the bottle, which when ignited can explode.
Just to point out the dangers of this stuff, I know a bloke who set fire to my college chemistry lab floor when he dropped a boiling tube of burning ether.
This concluded my first post, questions and comments will be appreciated.
#2
Posted 30 October 2007 - 01:45
#3
Posted 30 October 2007 - 04:24
My knoweledge of anykind of advanced physiscs and chemistry are a bit limited, though I studied all of my school's biology courses when I was in gymnasium. Got pretty good grades out of them too.
Looking forward for more.
#4
Posted 30 October 2007 - 08:03
#5
Posted 30 October 2007 - 09:13
#6
Posted 30 October 2007 - 10:49
Thanks for the sig and avatar, 'Dr.
#7
Posted 30 October 2007 - 11:11
http://uk.youtube.co...h?v=HpovwbPGEoo
Gotta watch this, It's cool.
EDIT: What the hell is with all the html?
Is that allowed on the foums now?
Edited by Warbz, 30 October 2007 - 11:13.
#8
Posted 30 October 2007 - 20:46
The Ruben's tube is nice, as the guy says it sound sets up standing waves along the gas hose which varies the amount of gas allowed out and thus the flame height. A standing wave is on where its wavelength is integer divisible by twice times the length of the barriers, in this case the end of the tube. So for a 3 metre tube you could use sound of wavelengths of 6, 3, 1.5, 0.75 m etc.
And Yes Redeemer depending on the project I wouldn't mind helping.
#9
Posted 31 October 2007 - 19:54
Thanks for the sig and avatar, 'Dr.
#10
Posted 01 November 2007 - 08:40
Get a toy car with a constant, and reasonalby slow speed 1 m/s, then attach a spring that can fire a ball vertically upwards. if you do this right you can get a parabolic path which lands back in the hopper.
Or can do standing waves as was mentioned in the ether trough, but I fear this requires too much outside material, you'll need an oscillator and a strobe light, both of which need to be tunable.
#11
Posted 01 November 2007 - 20:56
Thanks for the sig and avatar, 'Dr.
#12
Posted 01 November 2007 - 22:25
Redeemer, on 1 Nov 2007, 16:56, said:
Volcano.
Nah, how about this?
http://www.youtube.c...h?v=_ux8nSWmAz0
#13
Posted 01 November 2007 - 23:15
#14
Posted 06 November 2007 - 22:18
~Redeemer
Thanks for the sig and avatar, 'Dr.
#15
Posted 06 November 2007 - 23:26
So, I'm in favor of an experiment involving fireworks as the next discussion.
Regards,
Nuker
#16
Posted 07 November 2007 - 14:01
Firstly some cool science, Vandaium has four different oxidation states, starting with the yellow in the small beaker
The zinc in the beaker reduces the vanadium into a series of oxidation states, with the purple as the final state.
Now when I was in college (aged 18, circa 1870) I did an experiment and managed to have all 4 in one boiling tube, however I neglect to have a photo.
In chemistry you can identify compounds by heating them in a dry form, this excites an electron into a new state, when this state decays, the electron emits a photon (or a series of). The light is particular to each state and thus can be used to identify unknown compunds.
Sodium burns with a persistent Yellow flame
Potassium is often contaminated by sodium (they are hard to separate) so looking through some blue cobalt glass can help people distinguish the pale violet of potassium.
Copper provides a green/blue flame and Barium is green.
Each of these and many more are used in fireworks, to give spectacular results and for the viewing public, a rather pleasing display from the United States
@ Redeemer, you could do an experiment showing the content of sodium and potassium in common table salt and then a low sodium brand such as 'lo salt'.
All you need is a clean copper wire, (preferably cleaned using HCl) then dip that in the compoud, and place in a hot bunsen burner flame, the sodium rich salt with burn bright orange, (you can clean your original wire but i recommend a separate on for the potassium rich salt) and show people the lilac through some blue glass, it's also possible to see the lilac at the edge of the blue plasma in a hot bunsen flame, this was my best trick at college, I didn't need the glass.
Make sure the wire you are holding is in some insulating material such as wood, since I don't want you to burn yourself.
Edit: My next topic will relate to microwaves
Edited by Dauth, 07 November 2007 - 14:01.
#17
Posted 07 November 2007 - 20:49
~Redeemer
Thanks for the sig and avatar, 'Dr.
#18
Posted 19 November 2007 - 00:19
Regards,
Nuker
#19
Posted 19 November 2007 - 00:48
~R
Thanks for the sig and avatar, 'Dr.
#20
Posted 19 November 2007 - 10:20
On can indeed walk on water if you prime it with enough cornstartch, http://www.youtube.com/watch?v=wLWl80CaMjU...feature=related
Sorry for the long interlude, very soon I will describe how to find the speed on light using chocolate and a microwave.
#21
Posted 20 November 2007 - 23:04
Simple, but good if you can't think of anything else.
Or ... if you can get any liquid Nitrogen and some YBCO then i can tell you how to levitate stuff
And if you have a desire to kill yourself i can tel you how to make a cathode ray (electron beam) out of a disposable camera.
If you like any of these ideas then i'll explain them more.
Edited by Talus, 20 November 2007 - 23:05.
Ladies and gentlemen we are floating in space
#22
Posted 26 November 2007 - 10:49
A cool trick but very dangerous and one I DO NOT RECOMMEND TO ANYONE! is the liquid nitrogen dragon, take a mouthfull of the stuff but do not swallow, the heat from your mouth vapourises enough to leave a protective barrier between your flesh and the liquid nitrogen, all you have to do after that is exhale.
Speed of light using chocolate and a microwave. Microwaves work by ocsillating water molecules in the object they are cooking, as the water molecules move they heat the material around them, cooking the object (This is similar to the reason that people feel Carbon Dioxide heats the world, but tbh I can't be bothered to explain it all).
One can easily find the frequency of the microwave radiation used (probably a distribution, but you can use the mean).
Get your chocolate and melt it (however you wish to) then spread it as evenly as possible on a microwave suitable tray. Remove your turntable from the microwave so that it remains stationary for the experiment.
Place your plate fo now solid chocolate in the microwave and put on high power for about 30 seconds (or until you see places bubble), quickly remove the plate and measure the wavelength of the bubbles, hopefully it will look something like my terrible ascii art below.
__/\___/\___/\___/\___/\___/\___/\___/\__
Take the number of peaks, in a given range, (the longer the better), perform this calculation (preferably in metres)
length / (peak*2) and this will give the wavelength.
Multiply the wavelength by the frequency from the micorwave and Bob is indeed you uncle you have the speed of light using chocolate and a microwave.
Edit : Frequency fo microwaves is about 2.5GHz so the spots should be about 6cm apart if you do the experiment, that gives a wavelength of 12cm or 0.12m.
Edited by Dauth, 26 November 2007 - 10:54.
#23
Posted 26 November 2007 - 16:32
Regards,
Nuker
#24
Posted 26 November 2007 - 18:05
#25
Posted 27 November 2007 - 09:10
Nice post Dauth, both cases are quite interesting .
7 user(s) are reading this topic
0 members, 7 guests, 0 anonymous users